Leaking T-stat housing!
#12
and more problems arise with my monte.... a few days ago my ac controls went bad, the fan doesn't work on speeds 1 and 2 anymore but i've already done some searching around for that
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
#13
and more problems arise with my monte.... a few days ago my ac controls went bad, the fan doesn't work on speeds 1 and 2 anymore but i've already done some searching around for that
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
#14
I'm now being extra careful lol and I park about 4 inches away from them no matter how high or low they are
#15
you did figure out that it's the blower motor resistor, correct? Hate to see you replace the wrong part.
#16
I think the red will work fine for this. I have a mark just like that on the bottom side of my bumper. The asphalt was kinda sunk in under the tires and when the car rolled forward into park it scrapped.
#17
I'm going to get the ac controls from the junk yard first and try that, I can get it really cheap anyways then I'll buy the resistor if that's not the case
Is it bad Lou? I just touched mine up with the pen thing from duplicolor and it's barely noticeable
#18
and more problems arise with my monte.... a few days ago my ac controls went bad, the fan doesn't work on speeds 1 and 2 anymore but i've already done some searching around for that
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
and this happened a few days ago, my bumper was too low for a parking spot barrier thing lol
#19
Join Date: Apr 2010
Location: Mentor, Ohio
Posts: 12,236
There is a paper gasket for the T-stat housing. You might have to look up a different year 3800, but it does exist. My dad had one on his '98 Grand Prix and one of the gasket kits (not sure if it's LIM or UIM) had both the paper gasket AND the rubber ring style.
#20
yours is super low mike :p
Yup there is because I got this T-stat housing from a riviera, which is the one I tried polishing lol and it still had some of the gasket stuck on it :p
It's not leaking anymore though so its all good for now
It's not leaking anymore though so its all good for now
Thread
Thread Starter
Forum
Replies
Last Post
Repair Guide: 3.9L T-stat change (3.5l similar)
God_Bot
FWD Tech Guides '95-'07
8
03-06-2013 12:42 AM