Stutter/Putting Accelerating Wet/Cold
Monte Of The Month -- August 2014
Joined: Sep 2008
Posts: 25,145
From: Southeast PA
Use the schrader valve on the front of the engine. Wrap it up in some paper towels and press it with a screw driver to depressurize
Then after you do the work, you just turn the key to on for a few seconds, not start and let the pump prime the system again.
Then after you do the work, you just turn the key to on for a few seconds, not start and let the pump prime the system again.
Thread Starter
|
Joined: Apr 2012
Posts: 74
Thanks for the Info..
Drove car first time since starting this thread Today, It was 74 out today. Started her up waited a min took off and no Sputter. So it seems when cold/wet and not warmed enough its causing it.
Ill get plugs and wires done first, Then fuel filter, Air Filter
Drove car first time since starting this thread Today, It was 74 out today. Started her up waited a min took off and no Sputter. So it seems when cold/wet and not warmed enough its causing it.
Ill get plugs and wires done first, Then fuel filter, Air Filter
Thread
Thread Starter
Forum
Replies
Last Post
6th Gen ('00-'05): Eratic Stutter at all engine speeds
JC Colon
Engine/Transmission/Performance Adders
13
Feb 2, 2014 06:57 PM
Krysden
Monte Carlo Repair Help
2
Mar 23, 2010 07:59 PM
