I found this glancing around... something we might want to look at getting for us smaller engine guys?


http://mrzperformance.vstore.ca/prod...products_id/96

 

To be honest with you, I can't really see that doing a WHOLE lot. I mean, sure, I bet they'd help... but wouldn't you be better to just invest into something like rockers, or maybe even a cam? Then you can worry about the little stuff to free up extra top end hp...

I dunno, maybe I just don't see wasting money on a smaller underdrive pulley, versus the bad boy stuff...

I'm sure money is tight, as it is with all of us... but bang for buck, rockers should be your next mod

 

I think ZZPerformance andPFYC both have these.

 

when i did the UD pulley on my Z i didnt feel much performance at all. i also would look at rockers or other big mods.

 

how much HP do you think you would see from doing a mod like this?

 

I HATE being the bubble popper...

But to be honest... I highly doubt it would be enough to even register on a dyno...

It might help with a few crank HP, but by the time it transfers through the torque converter, transmission, and then ultimately your wheels, I don't think you would see ANY change

Sorry Vita... =(

Just my opinion though...

-Keegan

 

better to have the more experienced be hoenst and save me a few bucks...

 

yeah i'd have to agree, the UDP on my car they quoted 4-5 HP but by the time that reaches the ground it might barely be 3 hp and temp fluctuations, air temp/ pressure, all have a greater effect.

you'd be better off doing a coolent flush and cooler thermostat then spending the money on this mod. its not a bad mod just not cost effecent.