engine bay wires
I need an honest opinion on the engine bay...some of u vuys have seen my engine bay so I'm wondering should I go with mixed black and orange wire covers, or should I do black and orange electrical tape? The intake manifold is gonna be orange with black lines on it. Jus need a few votes nwhatnot
Wiring has always been something that, in my opinion, should not be the focal point. The standard black loom does the job just fine without overdoing it. I actually covered my aftermarket amp's red power cable with 1/4" ID black loom (in the engine compartment) so it wouldn't stand out.
Joined: Apr 2010
Posts: 12,590
From: Mentor, Ohio
Matt, I like your thinking. 90%+ of the time, I'll agree with your stance. Sometimes I see people that did knock out stuff with customizing there wiring harnesses (and typically it's not with off the shelf stuff from the parts store). But the other 10%, it becomes over bearing and does take away from what is important.
I think done tastefully as accents as opposed to taking away from the main attraction it is a good thing. Think of a woman wearing knee high socks, or thigh high fish nets
essentially they both do the same thing, but the visual it gives is remarkable
I would like to see pics of your engine bay so that we know where your starting point is. I know you have a black and orange theme going, but it may carry over too much if you start doing it in the engine bay as well, depending on how much you do. With your intake being orange and the obvious visual focal point they may take away from it.
essentially they both do the same thing, but the visual it gives is remarkableI would like to see pics of your engine bay so that we know where your starting point is. I know you have a black and orange theme going, but it may carry over too much if you start doing it in the engine bay as well, depending on how much you do. With your intake being orange and the obvious visual focal point they may take away from it.
ok so heres the engine bay with the cover on

this is with the cover off

i got the dorman replacement manifold with the felpro lower gaskets....painted it orange will have black stipes

this is with the cover off

i got the dorman replacement manifold with the felpro lower gaskets....painted it orange will have black stipes
Last edited by owens91; Sep 27, 2013 at 04:09 PM. Reason: was not finished
I don't know man, it looks pretty nice in there as it is
the wire covers would be the way to go, as the electrical tape would take away from what you've done, in my opinion.
the wire covers would be the way to go, as the electrical tape would take away from what you've done, in my opinion.
Thread
Thread Starter
Forum
Replies
Last Post
Cowboy6622
General Monte Carlo Talk
3
Feb 6, 2012 10:56 AM
TonySS2007
Engine/Transmission/Performance Adders
2
Feb 9, 2011 01:04 PM
jcr_kc@hotmail.com
Monte Carlo Repair Help
2
Apr 9, 2009 02:48 AM
RickCoMatic
General Monte Carlo Talk
5
Dec 22, 2007 10:45 PM


















