hi got a k&n cold intake will the wizaired go over it is it not just a heat sheild ?

 

If you purchased the K&N Intake Kit then it's a huge waste of money to throw that kit away for the wizaired.

But if you just have a K&N cone filter thrown on the end of the stock tubing and run a Hot-air intake (or a cheap-o ebay intake), I would buy the wizaired without a filter and put that whole system on your car.

 

i dont know what you guys are talking about with the pcm wires. i just took off my headlight and wiggled the two computer boxes around instead of disconecting them. mine felt stuck so thats what i did.

dont forget when in doubt use a hammer. lol and jk thats a horrible philosophy.

 

the wizaired requires you to remove the PCM and put it onto a tray.

 

which imo is a big pain

 

This is going to be the first of many mods for me . I was going to get the K&N, but after reading this thread, I'm leaning towards the Wizaired CAI now. What are the PCM wires you all are talking about

 

chibi i just read that again and you dont have to fully remove the pcm you just have to move it around so that its out of the way, i think it would be harder to put the pcm back in after the box was in

 

Oh... I just took the whole thing out and cleaned everything haha

 

ill probably do the same when i get a new pcm lol