Dyno today!
#32
Space I'll try not too, but then again, doesn't a budget build sound fun?
And I will definitely remember to do bearings and rings. Who knows what condition junkyard ones will be in haha.
And I will definitely remember to do bearings and rings. Who knows what condition junkyard ones will be in haha.
#33
Ouch, I was expecting more out of that Monte. I would almost guess that you have a 305, but that's too MUCH hp for that, lol. I bet your 6th gen is making more hp right now, but your 4th gen will be easier to wake up. Have fun with the build!
#34
x2 i figured it would be a little higher, but i guess 260-270 at the crank is good for a mild engine. makes more than mine :P
#37
...Hi Alex, thanks for all your super posts & sharing your knowledge with EnZo `Brock & member's 4-Sure.
I always learn so much about cars on the MCF from Member's like you...Thank You
__________________________________
Hi `Brock, have `fun with your Monte Project 4-Sure...
Fun does cost, but it sure is `FUN ~> EnJoy
#38
i meant in the bottom end of your motor. gotta figure cylinder pressure is going to go up with a turbo, and god only knows who has been playing with that motor, and what was done to it. i highly recommend getting the casting numbers off of the block and heads.
Thread
Thread Starter
Forum
Replies
Last Post
Mr.Monte
Headers/Intake/Exhaust
23
01-11-2012 10:58 PM
Cowboy6622
Engine/Transmission/Performance Adders
5
01-28-2008 09:11 AM