4th Gen ('81-'88): Is this true??
oh...no I don't have that stuff pulled yet. I WILL be pulling it though. Just might get it done tomorrow...LOL Might as well pull it all while I am at it!! 
MOTM Mod
Joined: May 2013
Posts: 5,498
From: Nebraska
I was doing some reading and came across this information " A mild, near stock 350 Chevy will redline around 5500 rpm, with the most power being at around 4500 rpm." Is this true??
I am currently running a 350 SBC in my 84 with a TH350 with B&M Shift kit. I shift manually with a B & M Z-Gate shifter. I was told the 350 sbc came out of a 1978 or 79 Camaro(can't find the #'s on the engine to know for sure). Stock cam from what I was told but I do not know that for sure as I have not dug into it to find out. Running long headers with full exhaust until I fix that in a few weeks to cut outs and glass packs with turn outs. Stock cast intake but changing to aluminum dual plane intake. 600 cfm 4bbl edelbrock carb manual choke and manual secondaries. HEI distributor. Stock rear end gears. Not sure what other information I can give or need to give.
By the end of the season I was shifting at 5200 RPM consistently from 1st to 2nd. I go to nearly the 1/8 mile before I shift from 1st to 2nd and then as I cross the 1/4 mile I am once again at 5200 RPM so I slap it into 3rd and begin slowing. While racing, if I slap it into 3rd, it just turns into a big blue turd and it has no pull like it does in 1st and 2nd.
If I am shifting at 5200 RPM, I am pretty darn close to redline if the above information is true. Is my shift point too high?
I am currently running a 350 SBC in my 84 with a TH350 with B&M Shift kit. I shift manually with a B & M Z-Gate shifter. I was told the 350 sbc came out of a 1978 or 79 Camaro(can't find the #'s on the engine to know for sure). Stock cam from what I was told but I do not know that for sure as I have not dug into it to find out. Running long headers with full exhaust until I fix that in a few weeks to cut outs and glass packs with turn outs. Stock cast intake but changing to aluminum dual plane intake. 600 cfm 4bbl edelbrock carb manual choke and manual secondaries. HEI distributor. Stock rear end gears. Not sure what other information I can give or need to give.
By the end of the season I was shifting at 5200 RPM consistently from 1st to 2nd. I go to nearly the 1/8 mile before I shift from 1st to 2nd and then as I cross the 1/4 mile I am once again at 5200 RPM so I slap it into 3rd and begin slowing. While racing, if I slap it into 3rd, it just turns into a big blue turd and it has no pull like it does in 1st and 2nd.
If I am shifting at 5200 RPM, I am pretty darn close to redline if the above information is true.
Is my shift point too high?
However the Chevelle with the 396 seemed to run the best when I dumped the Clutch at near 3500 rpm off the line it had the best time and I think we finally were running 12 something in the 1/4 mile. They thought I was running an automatic but that was just the was it sounded when you have the speed shift perfected.
Then when I purchased the 70-1/2 z/28 Camaro, now the Z/28 wrapped up a lot quicker then the Chevelle. I think I was shifting sooner and got there just a bit quicker. I never ran a race with an automatic, I think the Chevelles tach redlined about 56 to 5900 and the Z was closer to the 5200 you mentioned.
But this was a long time ago so I am just guessing from what I can remember.
All the stuff I had back in the day was lost in a flood so the tidbits are all I have.
I really like this forum cause you are bringing back some of the fun memories. Also brings back the sad memories when my wife thru out a bunch of my Auto parts before we moved to a different place.
Someone threw out car parts????? Oh no no no!!! LOL
It's probably best I don't have a significant other as I have no room in the closet...its where I keep my car parts, racing stuff, and tools!!! And I am NOT getting rid of my car parts, racing stuff OR tools!!! hahaha
Oh no no no!!! LOLIt's probably best I don't have a significant other as I have no room in the closet...its where I keep my car parts, racing stuff, and tools!!! And I am NOT getting rid of my car parts, racing stuff OR tools!!! hahaha
Joined: Jul 2006
Posts: 518
From:
Yeah a completely stock SBC will redline at 5500 with best power at around 4500 but is just ballpark.
Had a quick look at you site I see you have a 600 eddy carb. Probly have a matching intake?
Do you have headers and duals? Did you swap out the cam??
That's all things that will change the power band
Had a quick look at you site I see you have a 600 eddy carb. Probly have a matching intake?
Do you have headers and duals? Did you swap out the cam??
That's all things that will change the power band
Last edited by 88ss408; Feb 14, 2015 at 09:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
CHOWEE21
Interior/Audio/Visual Electronics
3
Jun 30, 2006 06:57 AM
mickey
Headers/Intake/Exhaust
6
Nov 22, 2005 05:31 AM
