I have been looking around for a wheel hub assembly and have found there are many brands and price points. Another point I see is some have a steel wire clip and some have a plastic wire clip. I would tend to thing the steel is better but I guess I could see how plastic might hold up better. I have seen full hubs from $40 to $300 so any input would be great. Thanks

 

I think ZZP sells them.

 

I have been dealing with this same problem; the ABS, Traction Control and Emergency Brake issue. Sometimes it would happen when raining, then it was random, then just contanstant.
I tracked it down too a grounding strap located under the Air Box. Removed the screw, cleaned up the ground and tightened it back inplace. Problem now gone.
Hope this helps.

 

GREAT tip! Thanks!

 

I went and bought the new Timken wheel hub got it for only $89 but I will have to check on this first before I put it on. I notice that it does come on and off sometimes but mainly stays on. I still have to check the connector on the hub also. I will post when I find out. Thanks for the tip! It could be that strap because I put the CIA in and the new PCM so I could have forgot to put it back on and/or did not put it back on right.

 

Just wanted to say THANKS! That was the problem! You just saved me $90! And $500 from a shop that said they would fix the hub also!

 

Do you have any pics of this grounding strap? Do I remove the airbox? I am so missing my ABS.

 

Sorry I was trying to get it done (Its been like 2 degrees here all week) and did not take any pix. Yes you will have to take the airbox off and basically right under where that airbox was is a screw and the grounding strap. Might have to take the PCM off too. There are good instructions on how to do this on the K&N site:
http://www.knfilters.com/instructions/57-3045_inst.pdf

Used the above link as a reference so you have pictures obviously skip the parts of the actual install of the K&N unit.