where on a 07 monte are the engine cover...
clips? and how hard is it to take off and put back on. gonna paint it real soon. ty guys!
Monte Of The Month -- November 2012
Monte Of The Month -- August 2015
Monte Of The Month -- August 2015
Joined: Aug 2011
Posts: 4,793
From: Ann Arbor, Michigan
It lifts off relatively easy. There more like pins (#3) that engage the cover but there's three of them; one by the throttle body and two on the opposite end. Part of the intake manifold body.
Thread Starter
|
Monte of the Month -- October 2013
Joined: Dec 2011
Posts: 1,174
Monte Of The Month -- November 2012
Monte Of The Month -- August 2015
Monte Of The Month -- August 2015
Joined: Aug 2011
Posts: 4,793
From: Ann Arbor, Michigan
Yes, grab the cover at both ends simultaneously and pull straight up. You could also try working the single pin end off, at the throttle body, first then pull up on the other end.
When re installing, make sure the hoses on the rear driver side are above the cover. You'll have to shimmy it under them first before aligning and popping it back down in place.
When re installing, make sure the hoses on the rear driver side are above the cover. You'll have to shimmy it under them first before aligning and popping it back down in place.
Thread
Thread Starter
Forum
Replies
Last Post
06BlackSS
General Monte Carlo Talk
9
Dec 13, 2006 07:57 PM
