Interior/Audio/Visual Electronics Discuss your audio/visual system and your interior here.

Speakers

Old Apr 19, 2010 | 08:48 PM
  #1  
rpd709's Avatar
Thread Starter
|
Joined: Aug 2006
Posts: 64
Default Speakers

Hello,

Wanting to replace the speakers in my Monte Carlo SS 04 w/ Factory Amp.

I busted one of the factory speakers so I figured I would upgrade them alittle.

I need a decent resonably priced set of speakers for the back and if their not too much trouble to deal with need a set of speakers for the front.

Is the speaker replacement easy for the front speakers or do you have to take the door panel and all that crap off?
 
Old Apr 20, 2010 | 07:36 AM
  #2  
jaws2008's Avatar

Monte Of The Month -- April 2011
GOT SPL
Joined: Oct 2008
Posts: 1,571
From: Lancaster PA
Default

Yes the door panel has to come off.

I would look for component sets for the door, so it remains the tweeter like factory.

Are you looking for any bass out of the speakers cause you will more or less loose some swapping out the factory speakers?

Whats reasonably priced qualify as?
 
Old Apr 20, 2010 | 10:28 AM
  #3  
Dbl_D718's Avatar
Joined: Sep 2009
Posts: 309
From: Morton, IL
Default

x2

The door panel has to come off for the fronts, but it's not all that scary. It's not really any harder than doing the rear speakers. You'll be wasting your time upgrading the fronts if you don't do components in my opinion. But you should know that without an aftermarket amp, they won't get as loud as factory speakers. Alpine Type X components would be a great choice and can be had on ebay for relatively cheap.

As for the rear speakers, like said above, they won't be as loud as factory if you replace them, mostly in terms of bass response. If you don't run a sub and don't plan on amping the speakers, you might be better off with factory.
 
Old Apr 20, 2010 | 07:46 PM
  #4  
04MonteLS's Avatar
Joined: May 2005
Posts: 3,221
Default

Originally Posted by rpd709
Hello,

Wanting to replace the speakers in my Monte Carlo SS 04 w/ Factory Amp.

I busted one of the factory speakers so I figured I would upgrade them alittle.

I need a decent resonably priced set of speakers for the back and if their not too much trouble to deal with need a set of speakers for the front.

Is the speaker replacement easy for the front speakers or do you have to take the door panel and all that crap off?
Yes it's easy and yes you have to take the door panel off.

I don't agree with the guys that are saying you'll lose bass response though, that was not my experience. Matter of fact, the bass sounded better, IMO, when I replaced my interior speakers however the volume did decrease noticeably. So to offset that I basically just had to turn the volume **** up higher to reach the same loudness as with the stock speakers. Reason being, when removed my stock speakers I noticed they were 2ohm drivers...I put in 4ohm drivers which essentially doubled the resistive load the amp was "seeing" which effectively halves the power output.

So if you're going to do this upgrade my suggestion to you would be to check what impedance your speakers are before you go and buy some, if they are 2ohms as mine were they I'd suggest replacing them with 2ohm drivers or accept the fact that once you do the upgrade your stereo won't be as loud as it once was at the volume level you listened to it.
 

Last edited by 04MonteLS; Apr 20, 2010 at 07:51 PM.
Old Apr 20, 2010 | 08:04 PM
  #5  
jaws2008's Avatar

Monte Of The Month -- April 2011
GOT SPL
Joined: Oct 2008
Posts: 1,571
From: Lancaster PA
Default

04MonteLS... was what you got with or without the factory HU. The HU makes a big difference as well.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
victoryred05
Interior/Audio/Visual Electronics
1
Dec 20, 2005 11:40 PM
eric618
Interior/Audio/Visual Electronics
20
Aug 24, 2005 06:00 PM
eric618
Monte Carlo Repair Help
0
Aug 22, 2005 05:23 PM
04MonteLS
Interior/Audio/Visual Electronics
10
Aug 13, 2005 03:14 AM
earthquake
Interior/Audio/Visual Electronics
1
Jan 14, 2005 06:20 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:12 AM.