General Monte Carlo Talk Talk about the Monte Carlo. Does not have to be your Monte. Can include pics and games.

7th Gen ('06-'07): Need help

Old Mar 16, 2019 | 07:15 AM
  #1  
skeeter 26's Avatar
Thread Starter
|
Joined: Feb 2015
Posts: 1
From: ohio
Default Need help

Heater ac rear defogger switch wont work it doesn't light up I replaced the resistor next to blower motor blower motor is good I tested it all fuses are good at its end any help would be greatly appreciated
 
Old Mar 16, 2019 | 09:54 PM
  #2  
Barovelli's Avatar
Monte Of The Month -- April 2016
10 Year Member5 Year Member3 Year Member1 Year Member
Joined: Apr 2010
Posts: 888
From: Monterey Bay Area, CA
15 Year Member
Default

Check the multi-pin connector that is under the passenger side kick panel. If it's line mine was you may not like what you find (charred plastic and burnt pins). Locate the rear defroster cable in the connector, it will be obvious if charred, Bypass the connector.

Better steps on this thread -> https://montecarloforum.com/forum/fw...-2007-a-41169/
 

Last edited by Barovelli; Mar 16, 2019 at 10:01 PM.
Old Apr 5, 2019 | 08:03 PM
  #3  
Skatulaki's Avatar
Joined: May 2018
Posts: 144
1 Year Member
Default

Disconnect wires from the switch to test switch itself ! Set your multimeter to Ohms, ( Horseshoe looking symbol Omega ) Put a meter probe on each tab of switch ( doesn't matter which one on which tab. With switch off you should read 1.0000 or no continuity ! turn switch on you should read continuity 0.0 or maybe 0.3, then switch is good. If it reads 1.0 its bad.
The resistor adjusts the speed of the blower motor and likely has no effect on the rear defrost. usually if this is bad, the blower motor will run full blast or not at all,

If your switch reads good, then you have to check and see if you have 12v coming into the IN wire at the switch ( with switch disconnected ) Switches generally have 3 prongs one marked NO, one NC, and the other PWR. NO Normally open , NC normally closed. are the switch out puts , the other is the power source, sometimes its just two prongs In and out !
If you don't have 12v on the in wire, the problem is between the switch and power source. If you have the 12V and 12Volts comes out of the switch then the problem is likely the device you are attempting to use, or a cut wire in between.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mr markuSS
Monte Carlo Repair Help
7
Aug 18, 2016 09:57 PM
Hailey2014
Monte Carlo Repair Help
0
Feb 23, 2016 07:43 PM
ChevygalSS
Monte Carlo Repair Help
3
Mar 8, 2015 08:04 PM
Lilmonte86
Monte Carlo Repair Help
5
Jan 18, 2014 09:50 PM
Harlan2012
Monte Carlo Repair Help
2
Feb 6, 2013 01:39 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:17 AM.