Ok I finally finished my swap an started my car it's ran ruff so I then cut it off let it sit for a day came back put coolant in it an wanted to figure out what else was wrong with it but in doing that my car cut off an I went to start it back up an now only the flywheel will turn does anybody know what the problem might be

 

What did you do for the swap?

 

Did you change the PCM? Unplug the MAF, check for CEL/SES codes.

 

i went supercharger an i turn the key annuffin else happens but just the flywheel spins thats it an the pcm was tuned at zzp

 

Did you do any security relearn procedures for the PCM?

 

Check for codes? Bad crank sensor?