Dyno today!
#32
![Default](/forum/images/icons/icon1.gif)
Space I'll try not too, but then again, doesn't a budget build sound fun?
And I will definitely remember to do bearings and rings. Who knows what condition junkyard ones will be in haha.
And I will definitely remember to do bearings and rings. Who knows what condition junkyard ones will be in haha.
#33
![Default](/forum/images/icons/icon1.gif)
Ouch, I was expecting more out of that Monte. I would almost guess that you have a 305, but that's too MUCH hp for that, lol. I bet your 6th gen is making more hp right now, but your 4th gen will be easier to wake up. Have fun with the build!
#34
![Default](/forum/images/icons/icon1.gif)
x2 i figured it would be a little higher, but i guess 260-270 at the crank is good for a mild engine. makes more than mine :P
#37
![Default](/forum/images/icons/icon1.gif)
![](https://montecarloforum.com/forum/avatars/themonteman-5662.gif?type=sigpic&dateline=1242883336)
![Roll Eyes (Sarcastic)](https://montecarloforum.com/forum/images/smilies/rolleyes.gif)
I always learn so much about cars on the MCF from Member's like you...Thank You
![Thumbsup](https://montecarloforum.com/forum/images/smilies/thumbsup.gif)
__________________________________
Hi `Brock, have `fun with your Monte Project 4-Sure...
Fun does cost, but it sure is `FUN
![ROTFL](https://montecarloforum.com/forum/images/smilies/lmao.gif)
![Smile](https://montecarloforum.com/forum/images/smilies/smile.gif)
#38
![Default](/forum/images/icons/icon1.gif)
i meant in the bottom end of your motor. gotta figure cylinder pressure is going to go up with a turbo, and god only knows who has been playing with that motor, and what was done to it. i highly recommend getting the casting numbers off of the block and heads.
Thread
Thread Starter
Forum
Replies
Last Post
Mr.Monte
Headers/Intake/Exhaust
23
01-11-2012 10:58 PM
Cowboy6622
Engine/Transmission/Performance Adders
5
01-28-2008 09:11 AM