Well...
ITS ON!!!
Installed the bottle bracket & bottle,
just picked up thae carb plate, and will install soon.
ill prolly leave it at that until october. so i can get a new car and finish the installation. if i do it now, ill prolly get to tempted to hit the button and blow the thing up. then ill be out of a car.

 

[sm=ttiwwp.gif]


[sm=icon_stickpoke.gif]


Cherry Hill..... Where is that in relation to Newark??? I spend quite a bit of time in the Newark/Elizabeth area on occasion.


TVW

 

its a good 1 1/2 to 2 hrs south

 

PICS of PROOF!!!



I like it there. Easy Access

 

Nice......

What did that set up run$$$$$.....

I'd like to have a NOS setup but I think I'll at least wait till the warranty is up... I’d be very hesitant to use it off the line but I could see where NOS would be useful to better my highway runs..

I keep hearing that these trans are kinda weak and will not be able to handle the abuse for long...

Although, it would be a good excuse to get one of those ZZP tricked out trannys...


TVW.....

 

The setup ran about $400. But i had to get an edelbrock Nitrous carb plate because i dont have a holley carb, and never will...
I also purchased the ZEX bottle brackets because the NOS ones would have scratched the bottle. The ZEX have the rubber coatings around the bands...

 

what size shot did you use and what hp gain or 1/4 time reduction did you see, im considering a 125-150 shot of nitrous for my mostly stock 305 in my 86 monte. i think it should help out my 1/4 mile time. im hoping for a 14sec or quicker with a a full exhuast/cut outs/nitrous/heads/cam/intake manifold/carb/back seat taken out/passenger seat out,no spare tire/ nothing in the trunk/fiberglass cowl induction hood/tires.