Lol, hello.

 

Anybody know what kind of horsepower gain you get from porting the supercharger blower? And does it require any kind of supporting mods?

 

the gains will depend on what you already have done to your car

 

The mods i have right now are overkill tuned pcm, 1.9 rockers, 3.5 inch sc pulley, downpipe, Powerlog and ported rear manifold, wizaired cold air induction, l67 high velocity throttle body 180 degree stat and colder spark plugs so with these mods what kind of horsepower gain could i expect with a ported blower?

 

i don't know how much u can expect to gain. but i do know that you should match it up to a north star throttle body so that everything matches up right.

also how are the 1.9 rockers treating you?? i was going to go that route but then i decided to go with a cam instead

 

Ok thank you i like the rockers definitely a noticible increase in pull through the higher gears and rpm's im sure not as noticible as a cam but i saved alot of money with going with the rockers since i dont plan to extensively mod my car i went with #105 crow cam valve springs to just to make sure i dont get valve float.

 

what is said tech you all speak of?

 

Over 8,000 posts here? You're pretty prolific on this forum.

 

I plan on getting a full size intercooler, dynotune and dropping to a 3.1 inch pulley anybody have any idea what kind of hp gains i could see from that? I already have CAI, 1.9 rockers #105 springs, 3.5 pulley,plog,ported rear manifold, downpipe, flowmaster exhaust, colder plugs, 180 stat, high velocity throttle body.

 

not a whole lot till you get rid of the plog, ported rear mani, dp and buy actual headers. after you do that with all your other mods plus a full size intercooler and a 3.1 pulley you will see somewhere around 260-265whp on a good tune

if you do all of this and install a gen v blower and drop to a 3.0 pulley you should see around 300whp on a good tune.