Does anybody have one for sale i did a whole top swap but I know this what I need to an the one I had is bad so anybody have oneet me know ASAP

 

You probably don't need the whole harness. ZZP sells a L67 swap kit so you can buy that and it will give you a L67 MAP harness you can splice in and a BBV harness assuming you want to use the BBV through the computer. You'll get more boost if you don't connect it and let it operate through vacuum. So really all you need is the MAP harness.

You may need injector connectors as well. I think if you had a 2001+ you will need these. Other than that all of your original harness should work.

However if you want to replace the whole harness its probably easier to get the L67 harness and in that case check Morad Parts as they usually have them.

 

Ok idk it's a sensor In the back of the supercharger idk what plugs into that an I know everything matching I just dont wanna go threw slicing them running into any problems

 

Take a picture, there is a harness on the engine that hooks up to a CA emissions air pump

So if you just have a connector sitting in the engine bay not plugged into something, it could be nothing.

 

That's probably your map, you need an extension to run back from where it was before.

 

Ok it's the map sensor does anyone have a layout diagram or anything show what goes where an etc

 

L36 to L67 Wiring Conversion Kit

Check that out

 

Also, only wiring harness compatible is the 04-05 monte carlo supercharged harness. Still not worth doing.

 

Anybody have one?????