Man I've searched high and low to find a way to get this power cable through the firewall to hook up my amp.

How have you guys done it?

Any advice will be greatly appropriated.

 

go through the passenger side of the car go about 6in off the floor panel and make sure once u drill the whole to but a rubber boot in it so ur wire doesnt get cut nd short out or put the wire through and use a hot glue gun to seal it off i have 0 guage nd i had no problem installing it so it shud work fine for u

 

What year is your car?

 

Heck. I got 0awg in mine..

back when I put 4awg through I attached it to a metal rod like an antenna and pushed it through. worked great for me at least..

 

Its on my youtube page... link in my sig

 

thats where i went with my cable also, the passanger side, just watch out for that one line running on the wall

 

My car is an 01 SS

 

i ran 4awg through my firewall.. it helps to put a little silicone lubricant on the wire to push it through that way..

watch trewyns video thats where i did mine too. theres plenty of room on that side.

 

you all do realize theirs a completely empty gasket on the driver side right?

mines through the passenger side. but that's only because it was convenient for me and i ran 1\0. but 4 gauge isn't as expensive would be worth the extra distance.

 

So where u grounding? I had mine attached to this huge nut and bolt on the right rear wheel well