1984 Monte Carlo intake manifold question
Thread Starter
|
Awaiting Email Confirmation
Joined: Dec 2014
Posts: 2
1984 Monte Carlo intake manifold question
I have a 1984 Monte Carlo. It is not the SS unfortunately. I want to know if someone could tell me if the stock intake manifold is cast iron or aluminum. I have tried researching it but have not found anything. I do not have the stock one any longer but just need to know if it was cast iron or aluminum. Thanks.
I have a 1984 Monte Carlo. It is not the SS unfortunately. I want to know if someone could tell me if the stock intake manifold is cast iron or aluminum. I have tried researching it but have not found anything. I do not have the stock one any longer but just need to know if it was cast iron or aluminum. Thanks.
In 1984..
They were using cast iron!
Welcome to the forum.
I do believe they were cast iron but I am sure other people on the forum will know more positively than I. When I got my 84, someone had already swapped the 305 for a 350 out of a 78 Camaro and it had a cast iron intake manifold. I am getting ready to swap that out for an aluminum Edelbrock RPM Performer dual plane.
LOL see above....David and I must have been composing at the same time!!!
I do believe they were cast iron but I am sure other people on the forum will know more positively than I. When I got my 84, someone had already swapped the 305 for a 350 out of a 78 Camaro and it had a cast iron intake manifold. I am getting ready to swap that out for an aluminum Edelbrock RPM Performer dual plane.
LOL see above....David and I must have been composing at the same time!!!
Last edited by P343; Dec 29, 2014 at 04:40 PM.
Thread
Thread Starter
Forum
Replies
Last Post
daves92camaro
Engine/Transmission/Performance Adders
2
May 21, 2013 10:23 PM
