Im going to put a filter in there, but right now it needs work. I had it running for a while and I guess my one bulb somehow came out of place. Needless to saw when I came out from letting my car run a while I saw smoke and ran and popped the hood and pulled out the assembly. lol and for the hole subject Im putting some fiberglass on both sides once I get the beam adjusted right, and I really like the LED idea, I'll have to give it a shot once its done.

 

Unless someone made their own, you should see drain holes too. Cause the people who manufactured the hood know rain happens and you need to drain it somehow.

 

So what's the deal with those LED lights under your headlight? Are they inside the housing or under it? Cost, install process... It looks cool.

 

Theyre just led strips under the housing. I had to adjust the headlight rubber trim, but it cost me about $40 with shipping for the strips. Theyre $18 a piece. I spliced into the parking lights for power, and mounted them with the double sided tape they come with.

 

Well I think they look great. Nice job. How hard was the install?

 

Read on the Impala board I'm on that, I believe Advanced Auto sells strips of leds for something like $15. If you'ld like I'll see if I can track down the thread on that site about them.

 

You mean this thread?

http://www.naioa.com/v2/modules.php?...wtopic&t=35556

 

That would be the one! :P Show off!

 

for leds, check out oznium.com, theyre the best leds i have seen lol theyre pretty sweet strips

 

Install isnt bad at all. Take out the headlight, figure where it should go, and stick em on.