2000 MC, 3.8 Crankshaft pully won't come off! Bolt is already off!
Thread Starter
|
Joined: Apr 2009
Posts: 35
2000 MC, 3.8 Crankshaft pully won't come off! Bolt is already off!
Hello all -
I have a 2000 Monte SS and I need to replace the crankshaft positioning sensor. I was able to get the bolt off with a breaker bar and the starter, but now I can't get the pulley off. It won't budge. I've tried wd40, pulling as hard as I can, hitting it with a rubber mallet, ect..
Anyone know how to get it off? My haynes manual says it doesn't need a puller kit.
I have a 2000 Monte SS and I need to replace the crankshaft positioning sensor. I was able to get the bolt off with a breaker bar and the starter, but now I can't get the pulley off. It won't budge. I've tried wd40, pulling as hard as I can, hitting it with a rubber mallet, ect..
Anyone know how to get it off? My haynes manual says it doesn't need a puller kit.
Joined: Feb 2008
Posts: 6,433
Anyone know how to get it off? My haynes manual says it doesn't need a puller kit.
This is what I used:
http://www.zzperformance.com/grand_p...=339&catid=111
Last edited by bumpin96monte; Apr 27, 2009 at 11:51 PM.
Thread
Thread Starter
Forum
Replies
Last Post
gerolf
Monte Carlo Repair Help
5
May 22, 2015 12:22 PM
erik2282
Monte Carlo Repair Help
4
Apr 27, 2009 04:32 PM
motivation2k3
Engine/Transmission/Performance Adders
1
Sep 4, 2008 07:15 AM
alkalinetri3o
Engine/Transmission/Performance Adders
0
Apr 13, 2008 05:58 PM
livinlow
Monte Carlo Repair Help
2
Mar 22, 2007 08:52 PM
