Last post in Friday's thread? Monte is still yellow, and I still hate winter. Getting some halogen HID lookalike bulbs for highs soon though. Should match my 6000k lows. Hope everyone has a restful night.

 

Soaxin, My best bet from what you said and your problems is the splice pack in this wiring diagram



It requires more investigating but heres a link to the diagrams.
| Repair Guides | Data Link Communications (2002) | Data Link Connector (dlc) Schematics | AutoZone.com
You have to make an acount to navigate them more but its VERY helpful.

 

also this buddy

Locate the EBCM/EBTCM under the instrument panel, to the left of the steering column.
Release the EBCM/EBTCM from its bracket using the pressure tabs.
Detach the electrical harness and remove the EBCM/EBTCM from the vehicle.
Installation is the reverse of the removal process. Verify that all electrical connections are secure.


hope it helps

 

Wow David... I got a headache just looking at that diagram... All the power to you...

 

Electronics are my thing. I see things like that and they just make sense to me haha. I like electronics. I feel like I can go inside the circuit and follow the paths of the electrons.

 

Funny, i did drive the 130 miles to the airport, so ha, and i have to drive about 80 miles from the airport in NY to my house.

 

Good evening all... Finally found some time for a cruise down to Bellingham, WA to pick up my Vogtland lowering springs... Hopefully will get them installed in the next couple of weeks... Can't wait, feel like a kid at Christmas...