Valve Cover Gasket Time!!!!
Valve Cover Gasket Time!!!!
So I know how to do this... but do you guys have any advice? Do you guys use any RTV and if so, what type?
Also, what is the torque on those bolts? Do you guys just put them on there with a quarter drive set and lightly torque, or do I need to get a quarter inch drive torque wrench to make sure I get it right?
And everyone I see lists "Without grommets" Are these the pieces that go into the valve covers and should I repalce those while I'm at it?
Also, what is the torque on those bolts? Do you guys just put them on there with a quarter drive set and lightly torque, or do I need to get a quarter inch drive torque wrench to make sure I get it right?
And everyone I see lists "Without grommets" Are these the pieces that go into the valve covers and should I repalce those while I'm at it?
Last edited by Cowboy6622; Dec 14, 2011 at 04:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
monte carlo 3831
Monte Carlo Repair Help
13
May 15, 2012 09:58 PM
MonteMan92
Engine/Transmission/Performance Adders
5
Sep 11, 2011 10:22 PM
70monte1
Engine/Transmission/Performance Adders
9
Jul 7, 2010 12:13 AM
prez
Engine/Transmission/Performance Adders
4
Jun 6, 2009 11:41 AM
