Ordered the last few mods:)
#1
Ordered the last few mods:)
We ordered the final performance mods for Dale this week. We ordered 1.8/1.85 split ratio rockers and a 3.4 mps. We went with the split ratio rockers instead of the 1.9 modified rockers because I didn't want to have to worry about doing springs. I like to do things right and didn't have the cash for springs. If I did the 1.9's and no springs I would worry constantly about a spring breaking a dropping a valve.
At the same time I also plan on installing autolite 104's and a new fuel filter. These mods should give us a nice 300 +/- horsepower which is plenty for me.
Does anyone know of a decent yet affordable dyno in northern new england? The 2 I know of are good but one charges $500 and the other over $1000, and if I had that kind of cash (which I don't) I'd drive to zzp and have them do it, lol
At the same time I also plan on installing autolite 104's and a new fuel filter. These mods should give us a nice 300 +/- horsepower which is plenty for me.
Does anyone know of a decent yet affordable dyno in northern new england? The 2 I know of are good but one charges $500 and the other over $1000, and if I had that kind of cash (which I don't) I'd drive to zzp and have them do it, lol
#5
...Making it better 4-Sure...We will be looking forward to your updated Mod's & the results.
Also, thanks for all your many posts helping other member's with their problems..It is noted & appreciated for real sure : )
Wish you and readers a Happy...Peace/Out
#7
Congrats! You're going to have fun once you get the rockers and pulley installed. I can't remember either what the shift points are on the ZZP PCM, but I would imagine that they wouldn't put it over 6000rpm. But like mentioned already, don't go any higher then that. Valve float is no fun.
#8
Thank you everyone. Its been a year in the making. I'll keep you posted on how it turns out
No problem, always glad to help
No problem, always glad to help
#9
I received the Rockers and pulley puller today. The rocker bolts and pulley should be here tomorrow and I'll install everything Friday night or Saturday.
When I drove the car today I did a few WOT runs to see the shift points and it always shifts right around or before 5900 RPMS at WOT so I'm in the clear
I just had a question, do I gap the 104's to manufacture specs or is there a preferred gap for cooler plugs?
When I drove the car today I did a few WOT runs to see the shift points and it always shifts right around or before 5900 RPMS at WOT so I'm in the clear
I just had a question, do I gap the 104's to manufacture specs or is there a preferred gap for cooler plugs?
#10
i did the 1.9's and shifts around 6100 rpm at WOT, been fine for over a year. zzp recommends nothing about 6200 rpm without changing the springs. grats on the mods, should pull great for you!
Thread
Thread Starter
Forum
Replies
Last Post
06BlackSS
General Monte Carlo Talk
10
01-13-2007 12:02 PM