6th Gen ('00-'05): Fuel door replacement
Joined: Mar 2014
Posts: 29
Exactly what he said. My method was by taking off the plastic around the fuel neck as it is much less work then removing the wheel well liner in my opinion.
The bolts are kind of tricky to get a socket wrench on, and if they are rusted be very careful about stripping them.
I stripped the top one of mine during the process and had to use a Dremel tool to cut the end off of it( being extremely careful with sparks near a gas cap ).
The bolts are kind of tricky to get a socket wrench on, and if they are rusted be very careful about stripping them.
I stripped the top one of mine during the process and had to use a Dremel tool to cut the end off of it( being extremely careful with sparks near a gas cap ).
When you take the plastic off the fuel neck theres only those 3 bolts holding it in right? And Thanks Guys I appreciate it
Yup, just need to wiggle it out
Joined: Mar 2014
Posts: 29
[QUOTE=WImonteman;627971]so there are bolts holding it on not rivetsUOTE]
There are three bolts you have to remove from the plastic piece that goes around the fuel neck then that same plastic piece has two lips holding it in place. once you remove it you'll see the two bolts holding the fuel door on.
There are three bolts you have to remove from the plastic piece that goes around the fuel neck then that same plastic piece has two lips holding it in place. once you remove it you'll see the two bolts holding the fuel door on.
Thread
Thread Starter
Forum
Replies
Last Post
Budsjlm
FWD Tech Guides '95-'07
8
Oct 29, 2015 05:01 PM
The_Maniac
FWD Tech Guides '95-'07
1
Jan 26, 2014 05:54 PM
fastback4
Interior/Audio/Visual Electronics
2
Dec 25, 2006 12:42 AM
