Custom Trunk Lid Panels / Vinyl graphics / etc.
Thread Starter
|
Monte Of The Month -- November 2009
Joined: Aug 2009
Posts: 1,123
From: northeastern Illinios
Lisa wants a thin red bow tie to match the grill BT, a red SS and the silver supercharged.....her request is layout NO.1 but with the colors it just doesn't read..I've gone back and trimmed out the SS with black (still drying) no.4 is my choice, It's Lisa's decision
Joined: Nov 2009
Posts: 4,861
From: Georgia
Correct Tim, I wanted it thinner to go with my red around my stripes and my grille bowtie(as seen below), I think I will stick to my original idea pic #1 since the ss was made big specifically for that layout, but just would maybe want the supercharged a little straighter across, looks like it droops down to the right a little? Maybe you can straighten it before you glue it and just show me a pic first, then you can trace where the placement is before the gluing is done? Like the S down a bit and the d up a bit. That's all I would like to see before final approval and gluing. IMO #4 is just too much red in the lower right with the ss that big. And if I went smaller with the supercharged and the ss I also could have put them inside the bowtie with ss under the supercharged, but this is what I ordered and I can't wait to see it done and maybe figure a way to do LEDs on it in the future!
Thread Starter
|
Monte Of The Month -- November 2009
Joined: Aug 2009
Posts: 1,123
From: northeastern Illinios
I can lower cost with a quanity run so this just may be something to consider for a group buy.....chrome , silver or metalflake silver.. the center color reflective red although the badge can certainly be set up any color desired.
I will also be offering the same set up in Bow Ties and cross flags....
solid colors or graphics on the BT.
chevy cross flags top 67' Camaro lower 62' Impala
Last edited by jarheadbobandmax; Jan 17, 2011 at 05:53 AM.
