Hard work but worth every minute....
#1
Hard work but worth every minute....
I hand polished some parts for the monte ss this winter....i may now have full blown arthritis in my hands now, but i think it was worth it.Attachment 10561 hope you guys like it! Like i said before, im learning this computer thing! I will show more pictures later! I had zzperformance do the whole motor and i couldnt be prouder! Thanks for looking!
Attachment 10562
Attachment 10563
Attachment 10564
Attachment 10562
Attachment 10563
Attachment 10564
Last edited by INTMD8R3; 05-14-2014 at 06:30 AM.
#7
I hit it first with a bench grinder steel brush wheel because it was as bad as im sure you guys have seen, and then i used a dremel tool for the nooks and crannys. Then i soaked it in a chemical from work called trichloroethylene. This stuff is amazing!. Then i just started sanding and sanding and sanding! Then i took after it with mothers polish....no b.s. Mothers polish! Lots and lots of it! I figure it cost me around a hundred bucks. Oh! And carpel tunnel surgery in the future! Thanks for the "likes" guys! This blower is installed already, photos to come soon of the engine compartment!
#8
I hit it first with a bench grinder steel brush wheel because it was as bad as im sure you guys have seen, and then i used a dremel tool for the nooks and crannys. Then i soaked it in a chemical from work called trichloroethylene. This stuff is amazing!. Then i just started sanding and sanding and sanding! Then i took after it with mothers polish....no b.s. Mothers polish! Lots and lots of it! I figure it cost me around a hundred bucks. Oh! And carpel tunnel surgery in the future! Thanks for the "likes" guys! This blower is installed already, photos to come soon of the engine compartment!
I LOVE MY MOTHER!!! (use mother's products ONLY on my Deuce)