Monte Carlo Forum - Monte Carlo Enthusiast Forums - Search Results

 
Search: Posts Made By: 03vaderSS
Showing results 1 to 25 of 211
Search took 0.01 seconds.
04-17-2019, 03:11 PM
Replies: 6
6th Gen ('00-'05): Spoiler install question
Views: 176
Posted By 03vaderSS

I had a body shop take a look since there is...

I had a body shop take a look since there is rough spots and rust under neath where the spoiler was. Most of it is under where there spoiler will sit. I honestly know it wonít come out perfect but if...
04-17-2019, 02:57 PM
Replies: 6
6th Gen ('00-'05): Spoiler install question
Views: 176
Posted By 03vaderSS

Also, 3m tape is needed too right? I could see...

Also, 3m tape is needed too right? I could see old spots on the new spoiler where it looks like they were
04-17-2019, 02:56 PM
Replies: 6
6th Gen ('00-'05): Spoiler install question
Views: 176
Posted By 03vaderSS

Ok thanks!

Ok thanks!
04-17-2019, 01:58 PM
Replies: 6
6th Gen ('00-'05): Spoiler install question
Views: 176
Posted By 03vaderSS

Spoiler install question

Hey guys and gals Iím going to be installing an 06 ss spoiler on my 03. The question is, what type of washers do I use, and do I use a washer on each side of the deck lid(2 per bolt, one on top and...
01-28-2019, 07:48 PM
Replies: 3
Views: 324
Posted By 03vaderSS

Ok and when adding the new spoiler, should I use...

Ok and when adding the new spoiler, should I use 3m tape on where I can see the old areas on the new spoiler where it looks like there was adhesive?
01-28-2019, 06:16 PM
Replies: 3
Views: 324
Posted By 03vaderSS

06/07 SS spoiler on 03 SS

I was reading an old post from chibiblack, in which you can take off the surfboard spoiler and the 06/07 SS spoiler will
fit directly. Anyone else do this? How should I remove the surfboard spoiler...
08-27-2018, 11:14 AM
Replies: 13
Views: 834
Posted By 03vaderSS

yes the gen 2 is adjustable. however i dont think...

yes the gen 2 is adjustable. however i dont think each end is extendable. i know must front strut bars can twist to extend or retract on most cars. unless the gen 2 can and im wrong. i have all...
08-26-2018, 04:42 PM
Replies: 13
Views: 834
Posted By 03vaderSS

both sides feel loose with the bar out. seems...

both sides feel loose with the bar out. seems like it wouldnt be a fight
08-26-2018, 04:17 PM
Replies: 13
Views: 834
Posted By 03vaderSS

i bet i can tap them out with a hammer.

i bet i can tap them out with a hammer.
08-26-2018, 01:42 PM
Replies: 13
Views: 834
Posted By 03vaderSS

so on your 04 you had to adjust the holes on the...

so on your 04 you had to adjust the holes on the brace mount to fit? and in your opinion, do you think it would make a difference in the front? i might not even change it
08-26-2018, 11:06 AM
Replies: 13
Views: 834
Posted By 03vaderSS

just the front. is the zzp gen2 brace better than...

just the front. is the zzp gen2 brace better than the factory? just trying to see if its worth intstalling. i do have upgraded sway bars front and rear as well as bc coilovers. not touching the rear...
08-26-2018, 08:21 AM
Replies: 13
Views: 834
Posted By 03vaderSS

so i have to remove the wheels to get under the...

so i have to remove the wheels to get under the car and check for a plat on each side? or should tapping lightly with a hammer work? in your opinion, do you think the zzp gen 2 is an upgrade front...
08-25-2018, 02:37 PM
Replies: 13
Views: 834
Posted By 03vaderSS

Question zzp gen 2 front strut tower brace question

hey guys, got a highly modded 03 ss. i still have the factory strut tower brace. i want to install my new gen 2 zzp front tower brace. only problem is, it looks like the factory screws are in the...
07-08-2018, 09:13 AM
Replies: 2
Views: 373
Posted By 03vaderSS

Arrow high sport factory ground effects sides and front fascia

hey guys, im looking to buy the high sport factory driver and passenger side ground effects as well as the lower front fascia ground effects. black would be great but any color is fine....
06-24-2017, 10:55 AM
Replies: 8
6th Gen ('00-'05): water leak on the floor?
Views: 594
Posted By 03vaderSS

oh wow

oh wow
06-24-2017, 09:51 AM
Replies: 8
6th Gen ('00-'05): water leak on the floor?
Views: 594
Posted By 03vaderSS

Cool water leak on the floor?

so my car is on the way home from zzp and i was told by tim that when the car was going onto the trailer, apparently water was leaking out from the door. they opened the door driverside i assume and...
12-08-2016, 03:10 PM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

Thanks for the help dude, if I keep this thing...

Thanks for the help dude, if
I keep this thing I'll hope
To meet you at a wbodymeet
12-08-2016, 02:23 PM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

Yea I guess that's all I can do, I'm numb though...

Yea I guess that's all I can do, I'm numb though and the wait is killing me I've given my every dime to this car and this is how it goes. I don't remember or have the dyno sheet from the 93 tune and...
12-08-2016, 11:33 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

On this set up it was 275 hp and 298 tq at 5200....

On this set up it was 275 hp and 298 tq at 5200. And how can I tell if there is a defect in the cam from the factory, that means id have to drop the motor and go back to step 1. Im out of money at...
12-08-2016, 10:35 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

Bump I know it's hard to tell But csn I email...

Bump I know it's hard to tell
But csn I email you a video of it idling with the cutout open? It doesn't sound like the cam is installed wrong but maybe you could
Tell
Better then I can? I can't...
12-08-2016, 10:31 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

If the cam was installed wrong then the car would...

If the cam was installed wrong then the car would be back firing but it doesn't. The pushrods are all new and matching
Lengths. The head gaskets are cometic and brand new as well. I can't see him...
12-08-2016, 09:40 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

All on the same dyno

All on the same dyno
12-08-2016, 09:38 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

The only other power mods I have added since last...

The only other power mods I have added since last time was an exhaust cutout, removed the high flow cat, e85, -8 fuel lines -6 return lines, 2.8 pulley , ported sc inlet, northstar tb kit, a second...
12-08-2016, 09:33 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

I wanted to run the 2 bar with the flashed PCM...

I wanted to run the 2 bar with the flashed PCM but he said it would be a more expensive tune and take longer to tune. I emailed Zoomer and he said either the cam is installed wrong or the timing is...
12-08-2016, 07:16 AM
Replies: 22
Opinion Needed: Help with 3800 xpz tuning.
Views: 1,394
Posted By 03vaderSS

My tuner brought the heads to his shop he always...

My tuner brought the heads to his shop he always uses. I asked for the flow numbers
But he didn't get them from the porter. He said the runners were only opened slightly more than they were. I know...
Showing results 1 to 25 of 211
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.